DST file extension (Tajima CAM) is used by embroidery machines and software. Tajima embroidery format is widely supported by embroidery machines and applications. DST file holds stitching instructions for embroidery machine, such as trim, stop, and jump. DST file also contains label metadata.
After converting the file to the new format, you will be able to use other programs to support it. Keep in mind, however, that the DST file after converting to EMB may differ slightly from the original. The most important information should be kept, but if you want the file after conversion from DST to EMB to be the same, you have to do this carefully and choose the proper application from the list below.
There is no guarantee, of course, that the conversion will come up to all your expectations, but it will certainly help you. If, after all, the effect of converting DST to EMB does not meet your expectations, you can simply try to find on the Internet a different version of your file in DST format, properly converted to a EMB file by someone else. If this fails, use the information provided in the further part of the website.
If after converting the file DST the desired result was not achieved, you can try to change the format of DST file to other than EMB. On our website you will find more information on the following conversion options
Unfortunately, if after performing the two previously described steps (trying to find your DST file converted by someone else, and the attempt to convert it to EMB on your own) you still have a problem with your file, then there are only a few solutions left. You can once again try to find and install an application that can open the DST file in its original format (without conversion to EMB file). Such a solution will be difficult to implement, but it certainly will give the best result.